To configure the VPN in multi-mode, configure a resource class and choose VPN licenses as part of the allowed resource. "Configuring a Class for Resource Management" provides these configuration steps. The following is an example configuration:Ĭonfigure a context and make it a member of the configured class that allows VPN licenses. Typically, the outside interface is connected The following is an example configuration:Ĭonfig-url disk0:/sm_s2s_ik1_ip4_no_webvpn.txtĬonfigure connection profiles, policies, crypto maps, and so on, just as you would with single context VPN configuration ofĪn ASA has at least two interfaces, referred to here as outside and inside. To the public Internet, while the inside interface is connected to a private network and is protected from public access. To begin, configure and enable two interfaces on the ASA. Then, assign a name, IP address and subnet mask. Its security level, speed, and duplex operation on the security appliance. The ASA’s outside interface address (for both IPv4/IPv6) cannot overlap with the private side address space. To enter Interface configuration mode, in global configuration mode enter the interface command with the default name of the interface to configure. In the following example the interface is ethernet0. To set the IP address and subnet mask for the interface, enter the ip address command.
0 kommentar(er)
